Installation Guides
SpaceTenet systems are engineered for tool-minimal installation without permanent structural changes. Every system can be installed, reconfigured, and relocated — no drilling into walls required for most configurations. Use the guides below to install your system correctly and safely.
Before You Begin
Before starting any installation, complete your Measurement Guide checklist to confirm your space dimensions, ceiling height, and floor conditions. Ensure all components are present by checking your order against the included packing list.
Axis™ Floor-to-Ceiling System
Single Pole Installation
- Position the base plate at the desired floor location.
- Extend the pole to approximately 50mm below ceiling height.
- Place the ceiling cap against the ceiling surface.
- Rotate the tension adjuster clockwise until firm resistance is felt. Do not overtighten.
- Verify vertical alignment using a spirit level on two perpendicular faces.
- Attach shelf brackets, hanging rails, or storage modules as required.
Double Pole & Corner Pole
Double and corner pole configurations follow the same tension-mounting principle. Ensure poles are installed in sequence from the primary anchor point outward. Refer to the included configuration diagram for your specific kit.
Frame™ Modular Partition System
- Lay out all frame panels and connectors on the floor before assembly.
- Connect base connectors to the floor channel (if included) or position base feet at marked intervals.
- Assemble vertical frame uprights and connect horizontal rails at the specified heights.
- Insert panel infills (glass, acoustic, or metal) into the frame channels.
- Secure top connectors and adjust leveling feet until the partition is plumb and stable.
Grid™ Display System
Grid™ panels mount to wall surfaces using the included bracket system. Mark bracket positions using the provided template, drill to the specified depth, insert wall anchors, and secure brackets. Hang Grid™ panels and attach display accessories as required.
Studio™ Workspace System
Studio™ desk and storage modules assemble using the included tool kit. Follow the numbered assembly sequence in the included guide. Monitor arms and cable management rails attach after the primary desk structure is complete.
Load Ratings
All SpaceTenet systems are rated for specific load capacities per shelf, rail, or panel. Do not exceed the rated load for any component. Refer to the System Compatibility Guide for load ratings by component type.
Need Help?
If you encounter any issue during installation, contact our support team or visit Start a Project to request a consultation.